User Manual Part 3

Page D-3
16 Sep 2015
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
C. APM (Cont) Electrical wiring Electrically wire and interconnect in
accordance with Figure 2-25 and
Figure 2-33.
Electrical wiring
- APM to
Modman
Connect the APM to the Modman with
two twisted shielded 24 AWG pairs with
Teflon insulation or aerospace grade
shielded CAT5/CAT5e cable, maximum
length 9.8 feet (3 m).
D. KANDU Physical Examine for physical damage.
Environmental conditions, refer to
Figure 2-26
Electrical wiring Electrically wire and interconnect in
accordance with Figure 2-26 and
Figure 2-33.
Mounting
Install location of KANDU is airframe
specific. KANDU could be installed in
unpressurized area near the tail
empennage of the aircraft or inside
pressurized area of the aircraft.
In case of KANDU install location is
inside pressurized location, the KANDU
to KRFU and KANDU to TMA
interconnect may be routed through a
Bulkhead Interface connector.
Electrical wiring
- KANDU to
TMA
Refer to JetWave™ System LRU
Installation, KANDU on page 2-6.
Electrical wiring
- KANDU
bulkhead
interface
Refer to JetWave™ System LRU
Installation, KANDU on page 2-6.
Section Parameter Item NA √ Value