User's Manual Part 6

Page 5-2

3 Mar 2017

23-15-29

SYSTEM DESCRIPTION AND INSTALLATION MANUAL

JetWave™ System

as an Electronic Flight Bag (EFB) or other portable computing device, an on-board portable device,

or an avionics device. Since the Aircraft loading procedures can vary due to different type of

uploading means, it is recommended to refer to the appropriate Aircraft Maintenance Manual before

attempting data loading of JetWave™ AES system.

C. Overview

This section contains the instructions for data loading of JetWave™

software to any of the

JetWave™ LRUs through the Ethernet interface maintenance port of Modman. Data loading of

JetWave™ system can be performed while:

• JetWave™ system is in normal operation

• During system initialization

• When in AES Critical Fault Mode.

The maintenance operator is responsible for determining which loads are presented to the

JetWave™ AES system through the Modman for data load. JetWave™ AES system in turn will

determine the files required to meet the data load request.

The JetWave™ AES system data loading of all LRUs including uploading of the AES configuration

data can be performed through Modman. For data load purpose, Modman acts as a gateway to

JetWave™ LRUs and LRUs themselves do the data load. It is not recommended to attempt field

data loading JetWave™ LRUs other than through the Modman.

The system configuration files are stored in nonvolatile memory in the APM and does not lose its

contents due to loss of APM power.

Upon transfer of the loaded software, the Modman makes sure that the software presented by the

data loader has been loaded correctly before responding that the load is complete and will report

part numbers of the loaded software.

For illustration purposes, snap shots of the AIT make F-SIM-LDR ARINC 615A data loader

simulator are included within this document.

(1) Parts Needed:

• Data load files from the Honeywell Portal.

• ARINC 615A compliant data. The JetWave™ AES system software is loaded through the

odman lo

ader.

NOTE: The JetWave™ AES loadable software part, part number varies for each release.

(2) System Software/Database Updates

Under normal circumstances, time required to carry out data load operation of all JetWave™

AES LRUs can be performed within a total time of between 1.0 and 2.25 hours. This includes

the Modman, KANDU, and antenna. Installation for the FMA takes significantly less time than

for the TMA.

The data sets as shown in Table 5-1 can be transferred through the data load port of the

Modman.

Draft as of 31 May 2017