User's Manual Part 6

Page C-11
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
A. Modman (Cont) Electrical
bonding
Bonding, refer to page 4-3
Electrical
wiring
Electrically wire and interconnect in
accordance with Figure 4-21 or
Figure 4-22 and Figure 4-35thru
Figure 4-37, depending on the
configuration being used.
Electrical RF
coaxial
Equalizer in the TX path
TX path loss, refer to Table 4-2. Modman
Cable Loss Values
Attenuator in the RX path
RX path loss, refer to Table 4-2.
Modman Cable Loss Values
NOTE: Input signal
range: -79 to -5 dBm.
Output signal range -30
to +5 dBm. Incross talk
requirement: -25 dBc.
Output cross talk
requirement: -40
dBc.APM
Physical Examine for physical damage.
Environmental conditions, refer to
Figure 4-21 and Figure 4-22.
Mounting Can be installed in any orientation. Refer
to Figure 4-21 and Figure 4-22.
Use 0.164-32 UNC-2A corrosion
resistant mounting fasteners.
Do not exceed 25 in-lb (2.8 Nm) when
you torque the screws.
Electrical
bonding
Electrically bond in accordance with
page 4-4.
Electrical
wiring
Electrically wire and interconnect in
accordance with Figure 4-23 and
Figure 4-35 thru Figure 4-37, depending
on the configuration being used.
Electrical
wiring - APM to
Modman
APM to Modman interconnect cable
shall use ARINC 664 compliant 2
Shielded Twisted Pair 24 AWG (or
Aerospace Grade Shielded Cat 5/Cat
5E Minimum). Part No. ECS 922404 or
Equivalent, with a maximum length of
9.8 feet (3 m).
Section Parameter Item NA √ Value
Draft as of 31 May 2017