User's Manual Part 6

Page 5-8
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
(g) Select “Server Configurations” on the left side of the screen and verify the settings
appear as in the screenshot below.
(3) Data-loading GXA with the AIT Flight Simulyzer Software
NOTE: Replace “<LRU NAME>” below with the LRU to be loaded.
(a) Power on the system.
(b) Wait until the Modman front panel LEDs (‘POWER’ and ‘ST
ATUS’) are both solid green
in color. This would indicate the system is in “Normal Operation” mode. If the MM does
not get to a solid green color, then that should be investigated before the SW upload
process begins.
(c) Make sure that the ‘Data Load Enable’ d
iscr
ete is set to the ‘Enabled’ state.
(d) On the installers data load PC, open a web browser and in the location bar enter IP
address 172.29.55.1, hit enter.
This will open the AES GUI as shown in the figure below.
Draft as of 31 May 2017