User's Manual Part 6

Page 6-5
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
There are two LEDs on the front panel of Modman. One is for the power and the second one is for
status. Use Table 6-1 to identify the current operating mode of Modman with the power LED
indicating powered up status.
On completion of AES system installation activities, the installer can view and make sure that the
JetWave™ LRUs status, AES configuration settings, discrete input and output status, and antenna
alignment status through the GUI as described in this section.
Once the Modman is powered up, the JetWave™
GUI page can be accessed. The JetWave™
system
GUI service is supported on AV1 10/100 Base T Ethernet interface. The Modman static IP
address assigned is 172.29.55.1 and the port number for the AES GUI service is 80. The laptop's
Ethernet port will need to be configured with a static IP address of 172.29.55.x, where x is 10 or
above.
Connect a laptop to the AV1 port of Modman through aircraft Ethernet interface. It is recommended
to use a laptop computer with the following minimum requirements:
• Intel i5 CPU
• 8 GB of RAM
• At least 500 MB of available hard drive space
• An available 10/100/1000 Ethernet interface
• Windows 7 operating system.
On any of the Internet browser (Internet Explorer 8 compatible), enter 172.29.55.1 in the address
bar. Login page will be presented as the root page, allowing entry of the user name and password.
Figure 6-2 shows the login page.
Table 6-1. Modman LED Status Indications
Status LED Mode
Off No electrical power/electrical power is supplied but
prior to boot.
Flash green at a minimum of 10 seconds Modman initialization
On - green Modman in normal operation
On - red Modman in Fault Mode
Draft as of 31 May 2017