User's Manual Part 6

Page 6-14
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
(3) It is required to do the automatic antenna alignment calibration with the Radome installed.
The antenna alignment process can be initiated through
the GUI interface. The JetWave™
system GUI service is supported on AV1 10/100 Base T Ethernet interfaces (AV1 being
default configuration, ports may vary depending on specific APM configuration).
(4) Automatic Antenna Alignment
The antenna alignment should be performed only after completion of system power up. The
health status o
f each LRU should be checked on the GUI, and there should be no display of
system muting. Only then should the Initiate button be pressed on the Antenna Alignment
GUI page. The JetWave™ system GUI service is supported on AV1 and AG1 10/100 Base T
Ethernet interfaces.
(5) On any Internet browser (Interne
t Explor
er 8 compatible), enter 172.29.55.1 in the address
bar. The Login page appears. Figure 6-12 shows the Login page.
Figure 6-12. GUI Login Page
(6) Enter the username and password below to access the maintenance interface.
• Username: "Maintenance" and Password: "Earthbound".
B. Positioning of Aircraft for Ant
enna Alignment
(1) On the GUI Calibrate Antenna Alignment page, as shown in Figure 6-13, the current location
of aircraft in terms of latitude and longitude is indicated al
ong with the selection of the
servicing Geo stationary satellite used for the antenna alignment.
Draft as of 31 May 2017