User's Manual Part 6

Page 6-17
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
Figure 6-14. GUI Antenna Alignment Calibration Page Extract
6.6 On-ground Testing and Commissioning
NOTE: There are restrictions to testing the JetWave™ system for the commissioning process.
Each country has its own restrictions to on-ground testing and transmission. Verify regulations
before testing the system. Particular attention must be observed the first time the system is turned
on and able to transmit. At this point the system will download a map detailing the areas where
transmission is and is not allowed. This map will take effect on the next power-up.
A. Testing and Commissioning Process with Restrictions
(1) The JetWave™ system under normal operating conditions mutes transmit and also disables
the m
odem when the Air/Ground status in "On Ground".
(2) The Air/Ground status will be set to "Air"
when one of the conditions that follow are met
(otherwise the Air/Ground status will be set to "On Ground"):
• IF AES Configuration System KANDU Ground Speed is being received from the
KA
NDU (Refer to SRS1525), and it has been received with non NULL valve, and is
indicating a ground speed of greater than 50 knots, or
Draft as of 31 May 2017