User's Manual Part 6

Page 7-33
3 Mar 2017
23-15-29
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
JetWave™ System
© Honeywell International Inc. Do not copy without express permission of Honeywell.
TMA (03) Position control
unit (05)
0x 0001 DSP fault Hardware faults and events:
- Replace the TMA.
NOTE:
Before removing the Tail
Mount Radome,
Honeywell recommends
manually steering the
TMA through GUI to a
safe antenna orientation
position. The TMA parking
position is included in the
AES System
Configuration File, which
can be accessed through
the GUI web interface and
by navigating to
Configuration File page.
Consult aircraft specific
SDIM for detailed
instructions.
0x 0002 AZ motor current draw
0x 0003 El motor current draw
0x 0004 Initialization incomplete
PSU (06) 0x 0003 OMAP PWR 3.3V: Out-of Spec
0x 0004 OMAP PWR 5V: Out-of Spec
0x 0005 MOT PWR 12V: Out-of Spec
0x 0006 LNA PWR 12V: Out-of Spec
Operational
information (FA)
0x 0000 Mode transition Info events - Recording what
happened in the LRU
0x 0001 Parameter
0x 0002 Event
0x 000A Standard electronic information
0x 000B Honeywell electronic information
0x 000C Subassembly information
IP Security (FB) 0x 0000 IP Security event Use well defined port and IP
Address
Reset (FC) 0x 0000 Power cycle Info events - Recording what
happened in the LRU
0x 0001 Watchdog
0x 0002 Software command
0x 0004 SW exception
Table 7-6. L3 Codes (Continued)
L1 L2 L3 Code L3 Description Repair Action
Draft as of 31 May 2017