Users Manual Part 3

Table Of Contents

(3) Make sure that all LRUs power up and report "OK" status.

(a) System status can be viewed at the AES Home and Status Info Page Figure 5-2.

(4) Check for system internal interconnect faults. Refer to JetWave™ MCS-8562 Terminal.

(5) Make sure the system is connected correctly to the navigation busses, check the system

for No traffic faults on the A429 ports. If No traffic faults are received, do as follows:

(a) Check wiring and or make sure that the APM is configured for how the system is

wired.

(6) Make sure that the cable calibration procedure has been done. Refer to Cable Calibration.

(7) Make sure that the navigation data is correct and that the antenna alignment has been

done.

(8) Check the system for User port Ethernet No layer 1 faults. If faults are received, do as

follows:

(a) Check the APM for correct configuration.

(b) Make sure that the connecting equipment is operating correctly.

(9) Make sure that the system has the correct software loaded. The GUI screen has a Software

Validity Flag, which if it is clear, then ALL system software is OK. If so, do as follows:

(a) Check for LRU software errors.

(b) Check for LRU hardware/software incompatibilities.

version of each LRU that matches with the expected system configuration. Valid

system configurations are defined for each Black Label software release and

communicated via the service bulletin process.

4. Incorrect Navigation Data

A. If the system is reporting labels missing, do as follows:

(1) Check that the APM is configured to have correct labels with the proper rate, latency on

the correct bus.

(2) Make sure that the labels are present on the bus.

B. If the system is reporting an incorrect label status on the bus (FW, NCD, FT), do as follows:

(1) Wait for equipment providing the labels to report Normal Operation.

5. System Will Not Connect to the Network

A. View the AES Home and Status Info Page Figure 5-2 to see reason transmission is muted and

address the reasons.

B. If the Radome is not installed, visually make sure that the Antenna is pointing toward the appropriate

satellite for the region.

C. The system can only transmit in authorized altidudes and will report if it cannot transmit for this

reason.

D. Make sure you have clear line of sight to the satellite.

E. Make sure the interconnection is intact and secured

Page 6-81

23-15-84

EFFECTIVITY

ALL

11 Nov 2020

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL

JetWave™ MCS-8562 Terminal