User's Manual

CI Wireless Inc. 1211 Ira E Woods Ave 61
Tel: [phone] Grapevine, TX 76051
9.5.7 Down Link Set Up for EKO-8 System
Down Link set up for an 800MHz system may be completed with any known number of
RF channels transmitting. Determine the proper output power level.
Display, * Readings/Controls: Adjust base station input power to TX PWR IN.
800M
Maximum Composite Power levels:
Lazer Power Input 0 dBm
Base Station Input Power 31 dBm
DL Power Out 36 dBm
Adjustment to these levels will allow EkoCel to operate to the proper power level as
indicated above.
Display
DL # Pwr dB: Set to XX dBm (set to desired output level in dBm
according to table) Press menu key, unit will self tune
within 10minutes. Typically within 2 – 3 minutes for
Peak Power levels settings.
DL # Peak Pwr: This level should be set no more than 1dB above the
desired maximum output power limit. This feature will
reset the remote to the desired output power should the
power exceed the maimmum output power limit.
Note: # - indicates remote under setup.
System will automatically reduce output power level if it exceeds 37dBm, which
is the Maximum peak limit setting,
Number of Total Active
System RF Channels
Output Power
Per Channel
Watts
4
2
1
.4
.2
.125
dBm
36
33
30
26
23
21
1
2
4 or less
8 or less
16 or less
24 or less