User's Manual

EMS Wireless Operator’s Manual
MirrorCell II CDM 812, CDM1912 Series
608112-1, Rev C
29
Note: The Usernames and Passwords should be changed during installation.
For example, to change a Username and Password:
SET UID# [username] <enter>
SET PWD# [password] <enter>
6.2 Basic Commands
The basic repeater commands are listed below.
 STATUS Displays Status Screen
 RESTART Begin Auto Setup Process
 MODEM Displays Modem Configuration Parameters
 GET PASSWORD Displays a list of User Names and Passwords (USRS 1
and 2)
 LOGOUT Exits or Logs off repeater
 EXIT Exits or Logs off repeater
 GET LOG Displays Log
 ALARMS Displays List of Current alarms and Trigger timestamp
 ALARM # Displays Alarm #’s Parameters (1-20)
 LIST ALARMS Displays a list of all alarms their assigned number and
status
 NEED UPDATES Logs user off terminal and Dial out to MUM to get all
settings for the site. Used when replacing a unit in the
field, or repeater parameters has already been setup at
the MUM
6.3 “Set” Commands
The “Set” Commands allow the user to change specific parameters that define the
repeater operation:
 SET UL OFFSET Up Link Gain Offset (0-16)
 SET DLPOWER Desired Down Link Power Setting (17-36)
 SET PROTOCOL System Technology (CDMA, AMPS, GSM)
 SET PEAK Maximum Down Link Output Power (18-42)
 SET PWD# Password for User ID # (8 alpha-numeric)