User's Manual

CI Wireless Inc.

1211 Ira E. Woods Ave., Grapevine, TX 76051

700-1004 Control Interface

Input Connectors

J1 - Controller Connection with 26 conductor ribbon cable from LCD display side and Power Led

of controller

J2 - Controller Connection with 26 conductor ribbon cable from the Key pad side of the controller

J3 - 10 Conductor Ribbon Cable Connection to 700-1002 Board Assembly J4, located on Heat

Sink, between Power Supply & PA

J4 - 15 Conductor ribbon Cable Connection to 700-1003 Board assembly J4, located on Fiber

Optic / RF Modem Panel

RS-485- Cables to bulk head “control” Connector on base of the remote.

Jumpers

SW 1 - SLAVE ENABLE

SW 2 - Address Enable 5 through 8

Address Jumpers

Voltage* Voltage*

SW Address Adjust Setting SW Address Adjust S

etting

3 R - 1 none <0.7 VDC 3 5 VR5 3.7 VDC

4 R - 2 VR2 1.75 VDC 4 6 VR2 4.7 VDC

5 R - 3 VR3 2.4 VDC 5 7 VR3 5.5 VDC

6 R - 4 VR4 3.0 VDC 6 8 VR4 6 VDC

* Monitor Test Point 1

Controls

VR 1 - Calibration for PA detected output power, see calibration tables.(Test Point 2)

VR 6 - Calibration RSSI, DL optional/RF loss (Test Point 3)

800 MHz or 1.9 GHz remotes may be configured as Master or Slave units. Units are configured

at factory normally with the differential being. Master remote is equipped with Fiber Optic RF

modem panel and the controller interface module assembly is different for each unit.

700-1004-X1X 1.9 GHz Units address 1 - 4

700-1004-X2X 800 MHz units address 5 – 8

700-1004-X3X 1.9 GHz Expansion (slave) unit address 1 – 4

700-1004-X4X 800 MHz Expansion (slave) unit address 5 - 8