User's Manual

CI Wireless Inc.

1211 Ira E. Woods Ave., Grapevine, TX 76051

8.2.2. SYSTEM SETUP ON THE HUB CONTROLLER

Setting up the hub unit is done in one of two ways, Manual setup or Auto setup.

A. Manual Setup

During the initial startup of the Hub the very first menu prompt to be encountered

is the setup menu. By pressing the UP or Down key you can either select the

manual or the auto setup. After choosing the correct setup method simply press

the MENU key to continue with setup. During Manual setup the following

parameters are necessary to set: Time; Date; System Format; RF Channels;

Load. To access the menus containing the settings other than Time/Date, press

the Menu key. Next to scroll through the settings press the Item key. Pressing

the menu key will only take you back to the TIME/DATE menu. To EXIT the

System Setup menus, press Item key until the prompt: “USE CURRENT

SETTINGS? “ Select yes and press menu. It will also be necessary to manually

set the gain.

B. General Notes on the Controller

To EXIT From ANY point simply press the DEL key, or select “yes” at the “Exit Current

settings?” menu.