User's Manual

EMS Wireless Operator’s Manual
EkoLink II
32
2. Note that, any unused ports on the Hub will indicate an alarm
condition until the user commands the Hub to ignore those ports. Please
refer to the System Initialization section for further details. Each Remote
has one alarm LED. When power is first applied to the Remote, its LED will
be amber for a period of 10 seconds. After the initial period, the LED will
indicate either an alarmed condition or normal operation. A solid green
LED indication on the Remote is normal and means that everything is
functioning properly. If any of the Remote LEDs are not green, there is an
alarm condition. Refer to section 5.0 to troubleshoot the problem.
2.9.1 User/Guest Login
When the Hub Controller first powers up, there is a start-up message
indicating the firmware release and copyright legends:
Hub Controller Program V0.99 [Build 04Oct02]
Copyright (c) 2002, EMS-Technologies, Inc.
If the user presses the ENTER key, the login prompt is displayed:
Hub Controller Program V0.99 [Build 04Oct02]
Copyright (c) 2002, EMS-Technologies, Inc.
Username:
There are two basic types of login available to the customer; guest, and
user. The guest login is for simple monitoring of the unit; ability to change
settings is limited. The user login is for the customer use and allows basic
system changes to be made to the module. Note that the login username
and password are CASE-SENSITIVE!
Hub Controller Program V0.99 [Build 04Oct02]
Copyright (c) 2002, EMS-Technologies, Inc.
Username: user
Password: ****
Access granted to user
2>