User's Manual

EMS Wireless Operator’s Manual
EkoLink II
4
Safety Considerations
When installing or using this product, observe all safety precautions
during handling and operation. Failure to comply with the following general
safety precautions and with specific precautions described elsewhere in this
manual violates the safety standards of the design, manufacture, and
intended use of this product. EMS Wireless Inc. assumes no liability for the
customer's failure to comply with these precautions. This entire manual
should be read and understood before beginning installation and operation.
CAUTION
Calls attention to a procedure or practice,
which, if ignored, may result in personal injury
or may result in damage to the system or system component.
Do not perform any procedure preceded by a
CAUTION until described conditions are fully understood and met.
Electrostatic Sensitivity
ESD = ELECTROSTATIC DISCHARGE SENSITIVE DEVICE
Observe electrostatic precautionary procedures.
Semiconductor laser transmitters and receivers provide highly reliable
performance when operated in conformity with their intended design.
However, a semiconductor laser may be damaged by an electrostatic charge
inadvertently imposed by careless handling.
Static electricity can be conducted to the laser chip from the center pin of the
RF input connector, and through the DC connector pins. When unpacking
and otherwise handling the transmitter, follow ESD precautionary
procedures including use of grounded wrist straps, grounded workbench
surfaces, and grounded floor mats.
If You Need Help
If you need additional help in installing or using the system, need additional
copies of this manual, or have questions about system options, please
contact: