User's Manual

EMS Wireless Operator’s Manual
EkoLink II
7
When the Hub Controller first powers up, there is a start-up message
indicating the firmware release and copyright legends:
Hub Controller Program V0.99 [Build 04Oct02]
Copyright (c) 2002, EMS-Technologies, Inc.
If the user presses the ENTER key, the login prompt is displayed:
Hub Controller Program V0.99 [Build 04Oct02]
Copyright (c) 2002, EMS-Technologies, Inc.
Username:
There are two basic types of login available to the customer; guest, and
user. The guest login is for simple monitoring of the unit; ability to change
settings is limited. The user login is for the customer use and allows basic
system changes to be made to the module. Note that the login username
and password are CASE-SENSITIVE!
Hub Controller Program V0.99 [Build 04Oct02]
Copyright (c) 2002, EMS-Technologies, Inc.
Username: user
Password: ****
Access granted to user
2>
The last entry “2>” is the prompt indicating the user’s level of privilege. The
prompt may be composed of several “reminders”; where a single capital letter
indicates a system change. These reminders are as follows:
<1> Login privilege level of “guest”
<2> Login privilege level of “user”
“A” An alarm is active
“C” Calibration tables are invalid; the default calibration
tables are in use.
“F” Settings do not agree with the stored values in flash memory.
This is usually the result of a change due to a user’s command
setting. All settings are read from the user’s settings in