User's Manual

EMS Wireless
EMS Wireless EkoMini Manual
10
Protocol Selection
To insure proper RF power output the proper protocol must be selected this insures the
software will properly distinguish the detected RF power level. CDMA is the only
protocol that requires a different look up table/RF calibration.
Protocol Selection Switch Five
CDMA On
All Other* Off
*All other protocols include; AMPS, GSM, PCS 1900, IDEN, ESMR, TDMA
Band Selection
EkoMini 1.9 PCS Band
, is available in two models. Selection of the proper operating
band A, B, or C with the model one and D, E, or F with model 2 is user selectable with
two dip switches as follows:
Band Selection Band Width Switch 3 Switch 4
A 15 on on
B 15 on off
C 15 off on
Band Selection Band Width Switch 3 Switch 4
D 5 on on
E 5 on off
F 5 off on
If the switches are improperly set (Off/Off), the unit will not function. This fault will be
indicated by the DC power on LED Indicator flashing green.
Note: If the band selection switches are changed after the unit is powered up, the unit
will not change frequency until the (1) power is cycled or (2) the reset switch is pressed
and held a EkoMinimum of 5 seconds, (Activating the reset switch will make the unit go
through the set up cycle).