User's Manual

EMS Wireless

EMS Wireless EkoMini Manual

detectable level. A quick check can be made by getting within a few feet of the Rerad

Antenna, while watching the Uplink RF indicator.

Primary Power

The EkoMini Unit operates on 9 VDC input power @ 6 Amps. This is supplied with a

regulated wall mount supply, which is UL and CSA listed. These are available to

operate on AC input voltages of 90 to 260 VAC.

Donor Antenna

This input/output is connected to an antenna, which is directed at the desired cell site.

Rerad Antenna

This input/output is connected to an antenna, which is mounted in the desired area to

be covered. The antenna should be mounted at a location where adequate coverage is

provided for the area desired while EkoMinimizing the potential of subscriber units

normally operating close enough to overdrive the unit.

Serial Number

Each unit has a unique electronic serial number. This number is displayed on the decal

on the unit and is also displayed with the history log when using the modem

interconnect.

Installation:

Note 1: Only qualified technicians should perform Installation and system set up. The

user is cautioned that modification or changes to this device not expressly approved by

the party responsible for compliance could void the user’s authority to operate this

equipment.

Note 2: Manufacturer’s rated output power of this equipment is for single carrier

operation. For situations when multiple carrier signals are present, the rating would

have to be reduced by 3.5 dBm, especially where the output signal is re-radiated and

can cause interference to the adjacent band users. This power reduction is to be

determined by means of input power or gain reduction and not by an attenuator at the

output device.

Note 3: This device complies with Part 15 of the FCC Rules. Operation is subject to

the condition that this device does not cause harmful interference.