User's Manual

EMS Wireless

EMS Wireless EkoMini Manual

STEP 2. Setting up the EkoMini.

A. Set the Report 1 Dial out Telephone Number. RP 1 DIAL

(Dial out Number. 20 digits)

B. Set The Pin Number (if Applicable). RP 1 PINN

(Pin Number. 10 digits, maximum)

C. Set Report 2 Dial out Telephone Number. RP 2 DIAL

(Dial out Number. 20 digits)

D. Set The Pin Number (if Applicable). RP 2 PINN

(Pin Number. 10 digits, maximum)

E. Set Delay for dialing out Telephone Number 2 after 1. RP 2 DLAY

(Dial Delay in minutes from Telephone Number 1, 0-999)

F. Set Report 3 Dial out Telephone Number. RP 3 DIAL

(Dial out Number. 20 digits)

G. Set The Pin Number (if Applicable). RP 3 PINN

(Pin Number. 10 digits, maximum)

H. Set delay for dialing out Telephone Number 3 after 2. RP 3 DLAY

(Dial Delay in minutes from Telephone Number 2, 0-999)

I. Activate Report Alarms Command RP ACTY

(Answer, Yes)

J. Set Answer Rings AR

(Answer Rings. 0-999, Default = 2)

K. Set Time TM

(format: 01:31:29 for 1:31 am or 13:31:29 for 1:31 pm)

L. Set Date DT

(format: 01/10/99 for Jan 10, 99)

Note: Report 1 Dial, is the number that the EkoMini will dial should an ALARM

condition occur. If desired the Report 2 Dial and Report 3 Dial can be set to

different Telephone Numbers. The Report 2 and Report 3 have by default a

cumulative delay set to 5 minutes each. So that: After 5 minutes of an alarm

state, Report 1 will be contacted. After 5 more minutes Report 2 will be contacted

and after 5 more minutes (or 15 minutes after the original alarm) Report 3 will be

contacted. If Report 2,3 Dial out numbers are not changed the EkoMini will

attempt to contact Report 1 when the delay time has expired. After setting up the

Dial Out number and if necessary the Pin number (used for some paging

systems) The Unit MUST be issued the Activate Report Alarms Command: ( set

rp actv Answer = yes ). If this step is skipped the unit WILL NOT report remote

alarms. The unit then should have the Answer Rings set, if they are not set the

EkoMini will DEFAULT to answer on 2 rings. The next step would be to set the

time and date.