User's Manual

3-11 Front Panel Operation
DataNex EMS Wireless, DATA-20 Digital Radio
3.4.5 System: Basic Card Setup
Basic Card Setup
QAM Modem
RF Tx
QMA
TXA
Card
Id
Card
Audio Enc
RF Rx
RXA
ENC1
DEC1
Audio Dec
Id
Card
Chnl Cd
MUX MUX0
CHC1
Id
Function Settings Summary
QAM Modem QMA, QMB QAM Modem installed in QAM Radio slots A or B
RF Tx TXA, TXB QAM Transmitter installed in QAM Radio slots A or B
RF Rx RXA, RXB QAM Receiver installed in QAM Radio slots A or B
Audio Enc ENC1,2,… Audio Encoder installed and identified (affects meter
selection of bargraph)
Audio Dec DEC1,2,… Audio Decoder installed and identified (affects meter
selection of bargraph)
MUX MUX 0,1,… Mux Module installed and identified
Chnl Cd CHC 1,2,… Channel Card installed and identified
Note: These are factory settings of installed cards, used to control appropriate displays in the
CARD VIEW screens.
Note: Pressing enter at each ID type brings up another screen with the Card Function shown
and the question: In System? Is displayed. Depending upon the card type, this screen also
indicates the base address. These windows are shown below: