User's Manual

A Division of EMS Technologies, Inc.
IM610852-1 Rev 01
10 Jan 2007
2
2850 Colonnades Court NW
Norcross, GA 30071
Phone: [phone]
Fax: [phone]
Every attempt has been made to make this material complete, accurate, and up-to-date.
Users are cautioned, however, that EMS Wireless reserves the right to make changes
without notice and shall not be responsible for any damages, including consequential,
caused by reliance on the material presented, including, but not limited to, typographical,
arithmetical, or listing errors.
Copyright Information
© EMS Wireless, Norcross, Georgia
Safety Considerations
When installing or using this product, observe all safety precautions during handling and
operation. Failure to comply with the following general safety precautions and with
specific precautions described elsewhere in this manual violates the safety standards of
the design, manufacture, and intended use of this product. EMS Wireless assumes no
liability for the customer's failure to comply with these precautions.
WARNING
WARNING calls attention to a procedure or practice, which if ignored, may result in
damage to the system or system component. Do not perform any procedure preceded
by a WARNING until described conditions are fully understood and met.
WARNINGS, CAUTIONS, AND GENERAL NOTES
FCC Class A
Note: This equipment has been tested and found to comply with the limits for a class A
digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
This Class A digital apparatus meets all requirements of the Canadian Interference Causing
Equipment Regulations. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Cet appareillage numérique de la classe A répond à toutes les exigences de l'interférence
canadienne causant des règlements d'équipement.L'opération est sujette aux deux
conditions suivantes: (1) ce dispositif peut ne pas causer l'interférence nocive, et (2) ce
dispositif doit accepter n'importe quelle interférence reçue, y compris l'interférence qui peut
causer l'opération peu désirée.