User's Manual

A Division of EMS Technologies, Inc.
IM610852-1 Rev 01
10 Jan 2007
7
2850 Colonnades Court NW
Norcross, GA 30071
Phone: [phone]
Fax: [phone]
Field Wiring instructions
The voltage input range for the EkoCell
TM
II PA/LNA is 100-240 VAC, single phase,
50-60 Hz.
Use supplied power cord, EMS Part Number PSC-532F for making connection to a
grounded electrical outlet.
Use only a grounded electrical outlet when connecting the unit to a power source.
If you do not know whether the outlet is grounded, consult with a qualified
electrician.
Reliable earth grounding of rack-mount equipment should be maintained.
Particular attention should be given to supply connection other than direct
connections to the branch circuit (e.g., use of power strips).
Wiring methods used for the connection of this equipment to the DC Mains supply
shall be in accordance with the U.S. National Electrical Code, ANSI/NFPA 70, and
the Canadian Electrical Code, Part 1, CSA C22.
Note: Antenna installation shall be in accordance with NEC Article 810
and CEC Section 54.
Refer to the following caution label on the unit prior to connecting power to unit: