User's Manual

EMS Wireless Operator’s Manual
EkoLink Plus Fiber Optic DAS
4
The screen of the coax cable must be connected to earth(grounded) at the
entrance to the building. This should be done in accordance with applicable
National Electrical Code(NEC) installation codes. In the U.S., this is required by
Section 820.93 of the National Electrical Code, ANSI/NFPA 70.
IC Requirements
` The Manufacturer's rated output power of this equipment is for single carrier
operation. For situations when multiple carrier signals are present, the rating
would have to be reduced by 3.5 dB, especially where the output signal is
re-radiated and can cause interference to adjacent band users. This power
reduction is to be by means of input power or gain reduction and not by an
attenuator at the output of the device.
Safety Considerations
When installing or using this product, observe all safety precautions during
handling and operation. Failure to comply with the following general safety
precautions and with specific precautions described elsewhere in this
manual violates the safety standards of the design, manufacture, and
intended use of this product. EMS Wireless assumes no liability for the
customer's failure to comply with these precautions.
WARNING
WARNING Calls attention to a procedure or practice, which, if ignored, may result
in damage to the system or system component. Do not perform any procedure
preceded by a WARNING until described conditions are fully understood and met.
If You Need Help
If you need additional copies of this manual, or have questions about
system options, or need help with installation and using of the system,
please contact EMS Wireless’ Customer Support Department.
2850 Colonnades Court
Norcross, GA 30071 USA
770.582.0555 ext. 5310
[e-mail]