Technical information

EMS SYSTEM 7000
7703 INSTALLATION, ISSUE V2.2 – 13/04/10
6
2.6 If the front panel has not already been unscrewed, undo and remove the 4 screws holding
the front panel to the main body of the receiver. Disconnect power and remove the battery if
fitted. The front panel will now be suspended from the black retaining strap.
2.7 Hold the receiver body in its final position and mark the 4 fixing holes. Knock out the
appropriate cable entry point to allow connections to be made to the receiver. Ensure that
the cable entry point selected affords the shortest possible cable run inside the receiver.
2.8 Reconnect the power cable and battery connections removed in 2.6 above. Before replacing
the front panel select the appropriate Receiver and Buzzer options using the switches as
shown below in accordance with Tables 2, 3 and 4 which outline the available options.
Switch Function Switch On Switch Off
1 Local Relay Latched On for period of
transmission + 2 seconds
2 Contact transmitter
type
N/C going open N/O going closed
3 Buzzer Alarm Buzzer permitted Alarm Buzzer Inhibited
4 Alarm Relay On for period of
transmission + 2 seconds
Latched
5 Buzzer No buzzer for valid
transmissions
Buzzer for period of
transmission + 1 second
6 Contact transmitters Alarm Local
Table 2
Switches 7 and 8 are used to select the type of transmitter being used
SW
7
SW8 Transmitter Type
Off Off Opposed Buttons for Full Alarm
Off ON Three Buttons for Full Alarm
ON OFF Non Opposed Buttons for Full Alarm
Table 3