User`s guide

4. Rotate Source selector on AVDH-1 front panel to the Camera position

5. Tune rack TV monitor to primary language channel (the installed camera in

the Chapel should be viewable on the monitor)

6. Launch D-70 Commander software on laptop computer

7. On left portion of software window, in the yellow box with red lines, click on

any inside corner or side while watching the rack TV monitor for camera

movement

ReceiveTestStream(AVDH‐1andAVDH‐2)

1. Connect a laptop to the AVDH with a HD-15 Male (VGA) to HD-15 Male (VGA)

cable

2. Connect to the front panel VGA input connector

3. Set laptop VGA display output resolution to 1024x768 or lower

4. Turn AUX input volume (right knob) on AVDH front panel counterclockwise

to minimum

5. Connect a 3.5mm Male to 3.5mm Male audio cable (included with accessory

kit) from laptop audio output to AVDH-1/AVDH-2 front panel AUX audio

input

6. Slide front panel AUX video input selector to right (VGA)

7. Rotate Source selector on AVDH front panel to AUX

8. Open Windows Explorer and connect to:

http://stream.lds.org/webcast

http://stream.lds.org/webcast2

9. Tune rack TV monitor to primary language channel

10. Turn rack TV monitor volume up to 50-60%

11. Turn AUX audio input volume up and listen for audio distortion

12. If audio distorts, turn AUX audio input volume down slowly until distortion

disappears.