User`s guide

a. You must enter a 15 digit number (e.g. 000000000055555) followed
by a “-“, then a 6 digit number (e.g. 666666), then a “-“, followed by
“00”.
b. It is possible that more than one install is occurring at the same time,
if so the stream may fail to start. If that occurs, use a different 15 digit
number, or a different 6 digit number
13. On the right of the Expression window, directly below the “Location” entry
box, click on “Connect”
14. A popup window requesting a username and password will appear
Note: To acquire the current username and password for testing follow the
instructions in the section titled “Certify Installation”.
The username and password are not to be shared with anyone; it is
only for use by an authorized installer. The password (and username)
is subject to change.
a. Enter the current username and password
b. Click “Ok”
15. In the center of the window, click “Start” to begin the stream
16. Verify stream by:
a. Connect a laptop to the local network
b. Open a browser and enter:
http://webcast.lds.org/55555-666666
Note: The inbound stream (see step 12 above) requires a 15 digit
number padded with 0’s on the left (e.g. 000001234567890,
000000000001234, et cetera) followed by a “-“ then a 6 digit
number, followed by a “-“ and ended with “00”. The viewer stream
is automatically shortened by the infrastructure by removing the
leading 0’s and the end “-00”.
17. Stop the stream and exit Expression encoder
WithHardware“Communicator”
Important: Installer is to ensure that all Unit-IDs for local units at install location
have been entered into the Meetinghouse Communicator. If unknown,
contact the local FM manager for the Unit-IDs. Information on how to
enter, is provided in this section.
1. In Chapel, turn on audio system
2. In Chapel, connect an audio source (e.g. iPhone, iPod) to an EJ-10/EJ-8
3. Connect EJ-10/EJ-8 to a Chapel microphone input
4. Adjust audio level at EJ-10/EJ-8 and in Chapel (at control pedestal) to
maximum
5. Turn on “Meetinghouse Webcast Communicator” hardware encoder device
6. On main screen select “Create Webcast”
7. If there are no Unit ID’s displayed
a. Select “Add”