Specifications

Parameter Description

Wireless Mode 802.11 b – This adapter can be compatible with both 802.11g and

802.11b wireless stations. If there are only 802.11b wireless

stations in the network, you can set the adapter to this mode.

802.11 g/b – If you have a mix of 802.11b and 802.11g wireless

stations in your network, it is recommended to setting the adapter

to this mode.

Preamble Mode The preamble defines the length of the CRC block for

communication among the wireless stations. There are three

mode including Long, Short and Auto. High network traffic areas

should use the shorter preamble type. If “Auto“ mode is selected,

the adapter will auto switch the preamble mode depending on the

wireless stations that the adapter is connecting to.

Note that the parameter is only active in the Ad Hoc operation

mode.

Channel Plan The available channel differs from different countries. For

example: USA (FCC) is channel 1-11, Europe (ETSI) is channel

1-13. The channel of the adapter has been set depends on the

country you are located. If you are in different country, you could

change the channel from the pull-down list.

PSP XLink Mode

Enable this function to support PSP XLink.

WMM Parameter QoS Enable – Enable this function to support WMM.

Power Save (APSD) Enable – Enable this function to support

WMM Power Save.

Fragment Threshold The value defines the maximum size of packets; any packet size

larger than the value will be fragmented. If you have decreased

this value and experience high packet error rates, you can

increase it again, but it will likely decrease overall network

performance. Select a setting within a range of 256 to 2432 bytes.

Minor change is recommended.

RTS Threshold Minimum packet size required for an RTS (Request To Send). For

packets smaller than this threshold, an RTS is not sent and the

packet is transmitted directly to the wireless network. Select a

setting within a range of 0 to 2432 bytes. Minor change is

recommended.