User guide

7
The 3.5mm connectors on the opposite end of each cable are orange. They
match the color of the mating connector on the back of the DSP and are
labeled “top” and “bottom”, so make sure that the cables are connected
correctly on the DSP side. Another way to remember : Black on the
board goes to the top connection on the DSP, and Green on the board
goes to the bottom connection on the DSP.
BLU-CIF Power
OLDER ACCESSORIES & THE NEW CIF BOARD
When using the new version of the BLU-CIF board with older versions of
the BLU-CC, BLU-IR or the MSC-C switches there will be some additional
wiring that must be done on the new BLU-CIF board for these to work
properly with the old template. No additional wiring needs to be done when
using the older versions of the BLU-CP and BLU-CS with the new BLU-
CIF board. When using the new BLU-CC2 with the new BLU-CIF board,
new templates are required but not additional wiring. Contact BSS Audio
for new templates.
Power Jack
The power jack for the BLU-CIF is located on
the bottom left side of the board; below the RJ-
45 block. The BLU-CIF is shipped with a
universal desktop power supply that plugs into
the power jack, and supplies it with 24VDC @
1.67A. The power cord on the supply plugs into
a standard 120VAC outlet.