Manual

BLU-CS Satellite Control

BLU-CS Wiring Instructions

IMPORTANT: CAT5e wiring for the RJ-45 connector needs to be

crimped to TIA/EIA 568B Standards (see below) on both ends of the cable.

You must crimp and test the wiring with an approved CAT5 568A/B

tester before connecting any cable between the BLU-CS and either a

BLU-CIF or BLU-IF Interface unit. Failure to crimp wiring to the correct

standard could possibly lead to component damage.

EIA/TIA568B

1. White-Orange

2. Orange

3. White-Green

4. Blue

5. White-Blue

6. Green

7. White-Brown

8. Brown

The BLU-CS is a satellite audio control

for BSS Audio London Series Digital

nal Processors. It is build on a

decora style panel for mounting in a

single gang electrical box. The front

side of the control has a lighted

momentary pushbutton switch for

turning on the satellite audio, and a pot

for adjusting the volume of the audio

signal. On the backside of the control

is a single RJ-45 Cat5e connector for

connecting the BLU-CS to the DSP.

PAGE 1
BLU-CS Satellite Control The BLU-CS is a satellite audio control for BSS Audio London Series Digital Signal Processors. It is build on a decora style panel for mounting in a single gang electrical box. The front side of the control has a lighted momentary pushbutton switch for turning on the satellite audio, and a pot for adjusting the volume of the audio signal. On the backside of the control is a single RJ-45 Cat5e connector for connecting the BLU-CS to the DSP.
PAGE 2
1 8 (Key on bottom) Backside of BLU-CS BLU-CS RJ-45 Pinouts 1. Power Button (Logic Input) 2. Volume (Logic Input) 3. Ref Voltage (+5V) 4. Not Used 5. Not Used 6. Power Button LED (Logic Output) 7. GND (C) 8.