User Manual

3
Controls & Functions
1. To (From) Telephone Line – allows any telephone line input.
2. To Telephone Set – allows parallel telephone set connection with EJ-10 – to
establish call.
3. Telephone Switch ON-OFF – captures and holds telephone line allowing you
to hang up the phone without losing the call – connects EJ-10 to phone line.
4. Audio Input – lowest lever input used to drive phone line (8 Vp-p) minimum
buffered stereo – for weak signal to microphone out – also highest level
output from phone line input.
5. Stereo Input – accepts stereo line level audio signal input – 1 volt RMS to
microphone – or 25 Vp-p signal to phone line.
6. Loudspeaker Level Input – accepts speaker level signals up to 10 volts RMS
and provides a power load 10 ohms – 10 watts for lowest distortion and noise.
7, 8 & 10. Mono RCA, 1/8” Mini & 1/4” Phone Auxiliary Line Level Inputs – accept
line level 1 volt RMS input – buffered inputs allow up to six different inputs
at the same time.
9. Cords Clip – patch cords are clipped to the EJ-10’s box so they won’t get lost.
Clip can be removed to add or subtract patch cords.