Specification Sheet

18
Decorative Multi Point Lock Trim for Swinging Patio Doors
DOOR CONFIGURATION #8 Specification Sheet for Components and Door Thickness
Door Configuration #8 American Cylinder Above Handle 5 ¼” Center to Center
Steel
Spindle
Rosette
Screws
Cylinder Tailpiece
Keyed Plates with American Cylinder Includes non-keyed thumbturn inside
Standard Components:
• Single Cylinder Tailpiece
• 3 ¾” Steel Spindle
• 1 ½” Rosette Screws
Standard Components:
• Thumbturn Tailpiece
• 3 ¾” Steel Spindle (half-spindle for fixed handle out/operating handle in)
• 1 ½” Rosette Screws
Non-Keyed Plates Includes non-keyed passage, fixed handle out/operating handle in
Standard Door Thickness: 1¾”
Standard Door Thickness: 1¾”
CONSTRUCTION KEYING
Charge for Construction Keying - $3.00 (NET)
• Locks that are both construction keyed and keyed alike in a house group will be charged a total of $5.00 (NET) per cylinder.
Charge for Re-Keying - $2.00 (NET) per Cylinder
• Locks that are keyed to code or keyed alike in a house group will be charged $2.00 (NET) per cylinder.
Keying to Code
• Order by indicating “Key Code XXXXX “ next to applicable locks.
Keying Alike
• Order by indicating “Keyed Alike” next to applicable locks if only one keyed alike group is wanted.
• If ordering multiple groups (houses) indicate “Keyed Alike House #_” next to applicable locks.
- Construction devices used on one or
more of last four positions.
- Dimples drilled in plug in this position.
• Lost ball system.
• Last four pin locations drilled for lost ball application.
• Master key pins used for code variability.
• Construction keys and owner keys sent separately.
• Order by indicating “Construction Keyed, House #_” next to applicable locks.
8
7
/8"
5
1
/4"
1
5
/8"