F13 Installation Guide

Installation Guide - F13 Mortise Lock
Plates and grip vary depending on style.
IN4-MORTISEINSTF13 REV 15A
Assemble to
bottom tube
See template for door prep
specications
2. Install Mortise Lock 1. Install Cylinder Plug
Outside Inside
3. Mount Inside and Outside Trim to Door
Install key 3/4 of the way into
the key cylinder and thread
it clockwise onto trim plate.
Install cylinder plug by
threading it clockwise
onto lock body
4. Install Key Cylinder
After key cylinder is installed,
secure cylinder by tightening
screw
7. Tighten Inside Lever or Knob
6. Install Trim Plate
Tighten Lever with 3/32
Hex wrench (provided).
See template for door
jamb prep specications
5. Tighten Key Cylinder
Instructions to reverse swing 8. Install Door Jamb
2. Pull out and rotate
Latch bolt to reverse
its direction.
1. Remove dowel
screw. (Replace
after reversing
swing)
Note: Notch on cylinder
plug must be in the 9
o’ clock position when
fully screwed onto lock
body.

Summary of content (1 pages)