Installation Guide

2 ⁄” or 2 ¾”
Backset
2 ⁄” Diameter Bore
⁄” Deep
2 ¼”
1 “
1” Diameter
Edge Bore
1. 1. Door Prep
2. Door Jamb Prep
4. Install Latch
Installation Guide - Passage / Privacy - Knob or Lever
5. Install Outside and Inside Trims.
Step 1. Position the outside trim through the bore hole.
Step 2. Fasten Inside Trim using two #8 machine screws
(provided), and install Privacy Pin.
Dummy Installation
Make sure the release hole lines up
with the privacy pin on the inside.
1/16” Deep
2 ¼”
1 ¼”
3. Install Strike Plate
Fasten Strike Plate
with #8 wood screws
(provided).
Place Plastic Alignment
Tool in bore hole. Insert
latch and fasten with
two #8 wood screws
(provided).
Arrow points
to door edge.
Surface mount to door with wood screws
(provided). Tighten set screw to secure
Rosette and Lever to threaded stud with hex
wrench (provided).
IN4-PASSPRIVLK REV. 3-15-2011
1 ⁄” Deep