Installation Guide

Page 19 of 67 pages
Document # E.0015.16.03 406984
To determine a strobe type, press OK at top of Control Panel. The ↵
character will be replaced by ‡. Screen will show:
05: STROBE TYPE
*Strobe None ‡
To select strobe type for this zone (Note: a list of strobe types
appears in the Appendix to this manual), press DOWN or UP keys at
top of Control Panel until desired strobe type is displayed, and then
press ESC key followed by DOWN key at top of Control Panel to
proceed to next sub-function.
Screen will show:
06: SWINGER STOP
No shutdown ↵
If no swinger shutdown exists for this zone, press DOWN key at top
of Control Panel to proceed to next sub-function.
To determine a swinger shutdown type, press OK at top of Control
Panel. The ↵ character will be replaced by ‡. Screen will show:
06: SWINGER STOP
*No shutdown ‡
To select swinger shutdown type for this zone (Note: a list of swinger
shutdown types appears in the Appendix to this manual), press
DOWN or UP keys at top of Control Panel until desired swinger
shutdown type is displayed, and then press ESC key followed by
DOWN key at top of Control Panel to proceed to next sub-function.
Screen will show:
07: INT. SIREN
Pulse A ↵
If Pulse A is the correct setting for this zone, press DOWN key at top
of Control Panel to proceed to next sub-function.
To change the internal siren type, press OK at top of Control Panel.
The ↵ character will be replaced by ‡. Screen will show: