Installation Guide

Page 22 of 67 pages
Document # E.0015.16.03 406984
14: REMOTE USER
*MASTER ‡
To select remote user for this zone (Note: a list of remote types
appears in the Appendix to this manual), press DOWN or UP keys at
top of Control Panel until desired remote user is displayed, and then
press OK at top of Control Panel. Now press ESC key at top of
Control Panel to return to Zone Attributes menu and press DOWN
key to proceed to next sub-function: Hardwired Zone
.
Screen will show:
ZONE PROGRAMMING
4. Hardwired Zone
Press OK at top of Control Panel. Screen will show:
01: HARDWIRED ZN.
64 ↵
If 64 is the correct zone number of the hardwired zone, press
DOWN key at top of Control Panel to proceed to next sub-function.
To change the hardwired zone number
, press OK at top of Control
Panel. The "6" in 64 will blink. Using the numeric keypad like a
cellular telephone keypad, change the "6" to the desired digit. The
"4" will then blink. Change the "4" to the desired digit. Now press
DOWN key at top of Control Panel to proceed to next sub-function.
Screen will show:
02: ZONE TERM.
N. Closed ↵
If Normally Closed is the correct setting for this zone, press DOWN
key at top of Control Panel to proceed to next sub-function.
To change the zone terminal setting, press OK at top of Control
Panel. The ↵ character will be replaced by ‡. Screen will show:
02: ZONE TERM.
*N. Closed ‡