Installation Guide

Page 23 of 67 pages
Document # E.0015.16.03 406984
To change the zone terminal setting for this zone (Note: a list of
zone terminal settings appears in the Appendix to this manual),
press DOWN or UP keys at top of Control Panel until desired zone
terminal setting is displayed, and then press ESC key at top of
Control Panel to return to Hardwired Zone menu and press DOWN
key to proceed to next sub-function: Peripheral Unit Attributes
.
Screen will show:
ZONE PROGRAMMING
5. PU Attributes
Press OK at top of Control Panel. Screen will show:
ENTER ZONE # 1
FRONT DOOR
To select peripheral unit attributes for this zone, press OK at top of
Control Panel. Screen will show:
01: SENSOR TYPE
Door ↵
If Door is the correct sensor type for this zone, press DOWN key at
top of Control Panel to proceed to next sub-function.
To change the sensor type, press OK at top of Control Panel. The ↵
character will be replaced by ‡. Screen will show:
01: SENSOR TYPE
*Door ‡
To change the sensor type for this zone (Note: a list of sensor types
appears in the Appendix to this manual), press DOWN or UP keys at
top of Control Panel until desired sensor type is displayed, and then
press DOWN key at top of Control Panel to proceed to next sub-
function.
Screen will show:
02: SENSOR S/N
1 ↵