Installation Guide

Page 36 of 67 pages
Document # E.0015.16.03 406984
change to Enable) and then press DOWN key at top of Control
Panel to proceed to next sub-function. Screen will show:
05: OPEN/CLOSE
Enable ↵
To enable logging of open/close events and proceed to the next
event logger option, press DOWN key at top of Control Panel. To
change the default from Enable to Disable, press OK at top of
Control Panel (if Disable is displayed, press OK at top of panel to
change to Enable).
On conclusion of all sub-functions (when sub-function 01 is again
displayed), press ESC key at top of Control Panel twice to return to
the System Options. Now press DOWN key at top of Control Panel
to proceed to the Access Codes menu.
3.2.4 Access Codes
From the System Options menu as shown in Section 3.2.3 above,
press DOWN key at top of Control Panel. Screen will show:
INSTALLER MENU
4: ACCESS CODES
To view the first function (Installer Code), press OK at top of Control
Panel. Screen will show:
01: INSTALL. CODE
9876 ↵
If 9876 is the desired installer code, press DOWN key at top of
Control Panel to proceed to next sub-function.
To change the installer code
, press OK at top of Control Panel. The
"9" in 9876 will blink. Using the numeric keypad like a cellular
telephone keypad, change the "9" to the desired digit. The "8" will
then blink. Change the "8" to the desired digit. Do the same for the
"7" and the "6"
When desired Installer Code is correctly displayed, press OK at top
of Control Panel to proceed to the next sub-function. Screen will
show: