Installation Guide

Page 64 of 67 pages
Document # E.0015.16.03 406984
If the signal level for this sensor is OK, the buzzer will sound and
screen will then change to:
SIGNAL LEVEL
OK
If the signal level for this sensor is not OK, the buzzer will not sound
and screen will then change to:
SIGNAL LEVEL
TOO LOW
Repeat Sections 3.2.10 and 3.2.11 for all zones. When zone
enrollment and place test are complete, proceed to the remaining
Installer Menu options listed in Section 3.2.12 below.
3.2.12 Others
From the Place Test menu as shown in Section 3.2.11 above, press
DOWN key at top of Control Panel. Screen will show:
INSTALLER MENU
12: OTHERS
Press OK at top of Control Panel. Screen will show:
OTHERS MENU
1: CLEAR EVENT LOG
This option is used when the Event Logger is full.
Press OK on top of Control Panel. Screen will show:
DEL EVENTS
OK
To clear Event Logger, press OK at top of Control Panel. Events will
be deleted and Others Menu will again be displayed.
If clearing of Events Logger is not desired, press ESC at top of
Control Panel twice to return to Others Menu and press DOWN key
at top of Control Panel twice to reach the next sub-option, Factory
Definitions.
Screen will show: