User's Guide

Page 23 of 46
Document # E.0015.16.02 406985
If the ID entered is correct, the system will respond with an "OK" voice
message; proceed to implement the desired function as set forth below.
To disarm the system, dial *10. An "Enter ID" voice prompt will sound.
Enter your User ID. A "System Disarmed" voice prompt will sound. The
system is now disarmed.
(Note
: If an alarm has already been issued, first dial *8 to disable the
siren. A "Done" voice prompt will sound and the siren will stop. Now dial
*10 to disarm the system.)
To implement Away arming
, dial *11. To implement Instant Away arming,
dial *12. If Quick Arming is not enabled (default state; see Section 2.6.4
below), an "Enter ID" voice prompt will sound. Enter your User ID. If the
ID entered is correct (or if Quick Arming is enabled), and if the system is
ready, a "System armed in Away (or Instant Away) mode" voice prompt
will sound. The system is now armed.
To implement Home arming
, dial *13 To implement Instant Home arming,
dial *14. If Quick Arming is not enabled
(default state; see Section 2.6.4
below), an "Enter ID" voice prompt will sound. Enter your User ID. If the
ID entered is correct (or if Quick Arming is enabled), and if the system is
ready, a "System armed in Home (or Instant Home) mode" voice prompt
will sound. The system is now armed.
(Note
: In all types of arming by telephone, if the system is not ready, a
"Not ready" message, followed by the number of the zone – for example,
"Not ready zone 4" – will sound, and the system will not be armed.
)
To obtain a system status report, dial *15.
To activate a PGM / X-10 module, dial *6, followed by the number of the
desired module. (Example
: to activate X-10 module 4, dial *64.)
To deactivate a PGM / X-10 module, dial *7, followed by the number of
the desired module. (Example
: to deactivate X-10 module 4, dial *74.)
To obtain help with telephone commands, dial *9. The first help sentence
will be heard. To hear the next help sentence, press * again and so forth.
To listen in to the premises from PSTN only, dial *3. To speak to the
inhabitants through the system speakers from PSTN only, dial *1.