User's Guide

Page 45 of 46
Document # E.0015.16.02 406985
SYSTEM TEST
1. Walk Test
This function is used to test a specific sensor. Press OK. Screen will
show:
PLEASE ACTIVATE
THE ZONE
Activate the sensor to be tested and press OK. If sensor is in good order,
two alternating screens will be displayed. One will show the sensor serial
number and type. The other will indicate the sensor signal level: SIGNAL
LEVEL OK or SIGNAL LEVEL TOO LOW.
If the sensor is not in good order, screen will show after 2 minutes:
PU
NOT FOUND
To test the system battery, use arrow keys at top of Control Panel to scroll
through System Test functions until screen shows:
SYSTEM TEST
2. Battery Test
Press OK. Screen will show:
TESTING BATTERY
PLEASE WAIT…
After about 30 seconds, if battery is present and in good order, screen will
briefly show:
BATTERY TEST
OK
If battery is missing or not in good order, screen will briefly show:
BATTERY TEST
FAILED
Display will then return to opening screen.