User Manual

Document # E.0015.16.07 396333
2.3 Installation
Installation of each door / window sensor is a three-step procedure. The sensor should first
be registered via the IntegrAlarm Control Panel. It should then be mounted on the door or
window to be secured, and then tested to confirm that it operates properly.
2.3.1 Registration
From Installer Menu on Control Panel, select ENROLL. Screen will show:
ENTER ZONE #
Use numeric keypad at right of Control Panel to enter the desired zone number. The
description of the zone number (e.g. MASTER BEDROOM) will appear at bottom of
screen. If zone description is correct, press OK at left of Control Panel. Screen will show:
PLEASE POWER UP
THE ZONE
Insert battery. Sensor will begin to transmit. If Control Panel does not identify sensor,
screen will show:
ZONE NOT FOUND
If Control Panel identifies sensor, Control Panel will emit an audible beep and screen will
show:
S/N: XXXXXX
TYPE: YYYY
where XXXXX is the sensor serial number and YYYY is either DOOR or WINDOW as
defined in the system. Ensure that the serial number displayed corresponds to the serial
number of the sensor and press OK at left of Control Panel. Screen will show:
ACCEPT ZONE DATA
NO YES
Press OK at left of Control Panel.
System will update zone enable parameters, sensor serial number and type, and mode of
operation (A, B or C).
2.3.2 Mounting
Remove the door / window sensor from its package. Select and mark the locations on the
door / window and the door / window frame inside the room, near the top outer corner of
the door / window, where the magnet block and the sensor assembly are to be installed.
The sensor assembly may be installed above or on the side of the door / window; if
installed on the side of a door, it must be installed on the side opposite the hinges. Ensure
that the door / window sensor will not interfere with the opening of the door / window.