User's Manual

Page 8 of 8 pages
Document # E0015.16.08 400280
Before mounting the smoke detector, it is necessary to ensure that all of the components
listed in Section 2.1 above are present and in good order. Disassemble the sensor
assembly and perform a visual inspection.
Write down the serial number from sensor base on a piece of paper for use in the
registration process as set forth in Section 2.3.2 below. Now, using two screws, attach the
mounting plate to the ceiling in the marked location as shown in Figure 1 below.
When the mounting plate is in place, take the sensor PCB and batteries to the Control
Panel and perform the registration process as set forth in Section 2.3.2 below.
Now return to the site where the sensor is to be installed. Insert the sensor batteries into
the sensor base and attach the cover. Ensure that the LED can be seen through the hole
in the cover.
Twist the cover into place ½ turn clockwise.
2.3.3 Testing
When the smoke detector has been registered and installed, test it by pressing the test
button on the cover until the alarm sounds, then release. The alarm sounds if all electronic
circuitry, buzzer and battery are working. The alarm may continue to sound for up to 10
seconds after the button is released.