User's Manual

Page 9 of 12
Document # E.0015.16.07 443713.DOC
Press OK at top of Control Panel. An ENTER ID prompt will be displayed and an "Enter ID"
voice prompt will sound. Enter your Installer ID.
Press the DOWN key repeatedly until the following screen appears:
INSTALLER MENU
10: ENROLL ZONES
Press OK at top of Control Panel. Screen will show:
ENTER ZONE # 1
FRONT DOOR
Overwrite the desired number using the numeric keypad and press OK at top of Control
Panel.
Note:
Overwriting a new zone number will not change the label on the display, but after
pressing OK, the default zone label for this zone # is automatically selected. The default
zone labels are set to the zone option selection.
Screen will show:
PLEASE POWER UP
THE ZONE
Connect siren to mains. The unit will now transmit its serial number, type and status (open
/ tamper) to the Control Panel.
If the Control Panel receives this information from the unit within a predefined time, screen
will show:
S/N: XXXXXX
SIREN [STATUS]
Screen will then alternate between the above and:
PRESS OK TO
ACCEPT ZONE DATA
Press OK to accept the unit type and serial number.
If the Control Panel receives no information from the unit within a predefined time, screen
will show:
PU NOT FOUND
Disconnect the unit from mains, reconnect and try again. If the same error message
appears, replace the unit.