User manual

The OneCommand Manager User Manual Page 101
Figure 58: Host Driver Parameters tab
Host Driver Parameters Tab Field Definitions
• Installed Driver Type - The current driver installed on this host. If there is more than one driver
type installed, the Installed Driver Types menu shows a list of all driver types and driver versions
that are installed on the adapters in the host.
• Adapter Parameter table - A list of adapter driver parameters and their current values.
Modify Adapter Parameter Area
• Adapter-specific information is displayed in this area. This can include value, range, default,
activation requirements and description.
Driver Parameters Tab Buttons (Not available in read-only mode.)
• Restore - If you changed driver parameters, but did not click Apply and you want to restore the
parameters to their last saved values, click Restore.
• Defaults - Click to reset all driver parameter values to their default (out-of-box) values.
• Apply - Click to apply any driver parameter changes. If you changed a driver parameter that is
not dynamic, you may need to reset the adapter port or create a new ramdisk and reboot the
system.
Note: Driver parameter values are not supported on hosts being managed through the CIM
interface.