User's Manual

2. Multi-screen Display and Sequencing

2.1. Screen Display.

Select any camera for Full screen display by pressing the Number button of the

desired camera. For 12ch, press 1 and then 2.

2.2. Multi-screen Display and Switching to Sequence Display.

1) Press [DISPLAY] buttons to activate the multi screen display. It is changed in the

order as shown below among your choice of SPLIT MODE.

2) To start Auto Sequence display, press [DISPLAY] buttons for 2 seconds and full

screen sequencing will be started.

Click this ICON by Mouse or SPOT OUT button on the remote control,

you will see following virtual controller

Main Monitor

3) The Auto sequence mode and dwell times are programmable in Switch set up.

For detailed information about configuring those, see “Switch Setup”. If the

sequence mode is not activated, it moves to Quad mode instead of Sequencing.

4) The Split mode is programmable in General set up.

3. Quick button for multi screen Display.

SPLIT MODE

In Auto Sequence Mode

Push to activate Auto Sequence