User's Manual

48
6.2. GENERAL
1. Access Port: Select “0001 ~ 9999”
Enter the port number the client uses to communicate with the NVR over the internet.
The default port is 7000. It is recommended to use a port above 1000.
2. Bandwidth: Select the network bandwidth to limit the amount of network resources
allocated to client connection. The default is unlimited: “
4 KBPS ~ 8 MBPS”
3. Access Block 1) Ping Block: No response to ping. By default OFF.
2) Scan Block: No response to Auto Scan from EMS. By default OFF.
4. Access Host and Host List: Allows you to access or deny specific IP address.
To allow or deny remote access requires you to enter a range of IP addresses as an
IP address and mask. Host List will be activated when you select deny or allowed.
5. Auto Port FWD:
Select the ADD button to automatically open ports for Router
communication with UPNP compliance.
6. 2 Way Audio: Support 2 way Audio between NVR and Remote Software