de en fr o9 micr it nl es Instructions for use for ENA Micro 9 One Touch The Instructions for Use has been awarded the seal of approval by the independent German Technical Inspection Agency, TÜV SÜD, due to its easy-tounderstand style, its thoroughness and coverage of safety aspects.
Table of contents Your ENA Micro 9 One Touch Control elements 34 Important information 36 Proper use................................................................................................................................................................36 For your safety........................................................................................................................................................36 1 Preparing and using for the first time 38 JURA on the Internet...........
de Table of contents Descaling the machine .........................................................................................................................................52 Descaling the water tank.......................................................................................................................................53 Cleaning the bean container................................................................................................................................
Control elements Control elements 1 6 2 micro 9 7 8 3 4 5 9 1 2 3 4 5 34 Water tank Mains cable (back of the machine) Milk pipe Coffee grounds container Drip tray 6 7 8 9 Bean container with aroma preservation cover Hot-water spout Height-adjustable dual spout Cup grille
de Control elements en fr 8 1 9 2 it 3 10 4 11 5 12 6 13 14 7 nl es 1 Cover for powder chute for ground coffee 2 Powder chute for ground coffee 3 Display 4 c Maintenance button 5 / Cappuccino button 6 ( Latte Macchiato button 7 Rotary Switch status display 8 9 10 11 12 13 14 Cover cap for grinder adjustment switch Grinder adjustment switch g Rotary Switch m Hot Water button < Espresso button Q On/Off button > Coffee button pt ru 35
Important information Important information UU In the event of signs of damage, Proper use The machine is designed and intended for private domestic use. It should only be used for coffee preparation and to heat milk and water. Use for any other purpose will be deemed improper. JURA Elektroapparate AG cannot accept any responsibility for the consequences of improper use. Before using the machine read these instructions for use thoroughly and completely and comply with the instructions they contain.
de Important information UU Never allow the mains cable to UU UU UU UU UU UU loosely hang down. The mains cable could pose a tripping hazard or become damaged. Protect the ENA from environmental influences such as rain, frost and direct sunlight. Do not immerse the ENA, mains cable or connections in water. Do not put the ENA or any individual parts in the dishwasher. Switch your ENA off before cleaning work with the On/Off button.
1 Preparing and using for the first time People, including children, who 1 Preparing and using for the first time do not have the physical, senUU sory or mental capabilities to use This chapter provides you with the information the machine safely or you need to use your ENA without any problems. will prepare your ENA step-by-step to enjoy UU are inexperienced or lack knowl- You your first perfect cup of coffee.
de 1 Filling the bean container CAUTION Coffee beans which have been treated with additives (e.g. sugar), ground coffee or freeze-dried coffee will damage the grinder. T Only use untreated coffee beans to fill the bean container. T Remove the aroma preservation cover of the bean container. T Remove any dirt or foreign objects from inside the bean container. T Fill the bean container with coffee beans. T Close the bean container.
1 Preparing and using for the first time T Fill the water tank with fresh, cold water and reinsert it. T Place a receptacle (at least 500 ml) under the hot-water and dual spout. T Remove the water tank. micro 9 T Fill the water tank with fresh, cold water and reinsert it. PRESS RINSE k T Press the Rotary Switch. FILTER RINSING, water flows out of the hot-water spout. EE You can interrupt rinsing of the filter at any time by pressing any button.
de 2 Adjusting the grinder You can adjust the grinder on a continuous scale to suit the degree of roast of your coffee. Preparation CAUTION Milk, sparkling mineral water or other liquids can damage the water tank or the machine. T Only fill the water tank with fresh, cold water. CAUTION If you adjust the consistency of grind when the grinder is not operating, the grinder adjustment switch could be damaged. T Only adjust the consistency of grind when the grinder is running.
2 Preparation Espresso, coffee Preparation of espresso < and coffee > follows this model. T Immerse the other end of the milk pipe in a receptacle with milk (figure: optional JURA 0.4 litre stainless steel vacuum milk container). Example: Proceed as follows to prepare one coffee. Precondition: READY is displayed. T Place a cup under the dual spout. > T Press the Coffee button to start preparation. COFFEE, the preset amount of water flows into the cup. Preparation stops automatically.
de 2 Example: Permanently adjust the amount of water for one coffee to the cup size. Precondition: READY is displayed. Milk is connected to the dual spout. T Place a cup under the dual spout. / T Press and hold the Cappuccino button. CAPPUCCINO / T Continue to hold the Cappuccino button down until ENOUGH MILK ? appears. / T Release the Cappuccino button. The milk foam is prepared. T Press any button as soon as there is sufficient milk foam in the cup.
3 Daily operation 3 Daily operation Switching on the machine Daily maintenance of the machine and hygiene when handling milk, coffee and water are key to a perfect coffee result in the cup every time. You should therefore change the water daily. T Place a receptacle under the dual spout. Q T Press the On/Off button to switch the machine on. HEATING RINSING, the system rinses itself.
de 4 Example: Permanently change the coffee strength (FLAVOUR) for espresso from STRONG to NORMAL. Precondition: READY is displayed. k T Press and hold the Rotary Switch until RINSE appears. g T Turn the Rotary Switch until PRODUCT is displayed. k T Press the Rotary Switch to enter the programme item. SELECT BUTTON EE Next select the button of the product for which you would like to make settings. No product is prepared at this point. < T Press the Espresso button.
4 Permanent settings in programming mode Energy-saving mode The energy-saving mode (Energy Save Mode, E.S.M.©) helps you to prevent your machine from consuming power unnecessarily and to actively save energy: UU UU ENERGY p UUSoon after the last preparation, the ENA stops heating up. After about 5 minutes the message ENERGY ON is displayed. UUBefore you can prepare a speciality coffee, speciality coffee with milk, or hot water, the machine must heat up.
de 4 Example: Change the setting such that cappuccino frother rinsing is performed immediately after preparation of a speciality coffee with milk. Precondition: READY is displayed. k T Press and hold the Rotary Switch until RINSE appears. g T Turn the Rotary Switch until RINSES is displayed. k T Press the Rotary Switch to enter the programme item. INIT RINSE g T Turn the Rotary Switch until C-RINSE is displayed. k T Press the Rotary Switch to enter the programme item.
5 Maintenance 5 Maintenance Your ENA has the following integrated maintenance programmes: Cappuccino frother cleaning (C-CLEAN) Rinsing the machine (RINSE) Cappuccino frother rinsing (C-RINSE) Cleaning the machine (CLEAN) Changing the filter (FILTER) Descaling the machine (DE-SCALE) UU UU UU UU UU UU EE You can start the maintenance programmes at any time in programming mode (programme item RINSE).
de 5 k T Press the Rotary Switch to start cappuccino frother cleaning. Maintenance T Press the releasing devices and pull the dual spout down and off. CLEANER FOR CAPPU. en T Remove the milk pipe from the receptacle with milk. T Pour 250 ml of fresh water into a receptacle and add one capful of milk system cleaner. T Immerse the milk pipe in the receptacle. T Place another receptacle under the dual spout. fr T Push the milk system down and remove it.
5 Maintenance T Reassemble the milk system, noting the numbering on the parts. k T Press the Rotary Switch to confirm the setting. OK INSERT FILTER 1 2 3 T Remove and empty the water tank. T Open the filter holder. T Insert the filter cartridge into the water tank, exerting slight pressure. T Insert the assembled individual parts into the dual spout and press them together. T Fit the dual spout on the machine. It will click into place audibly. T Close the filter holder.
de 5 Changing the filter EE After 50 litres of water have flowed through, the filter will cease to work. Your ENA will automatically prompt you to change the filter. EE After two months, the filter will cease to work. Set the date on the date plate on the filter holder in the water tank. EE If the CLARIS Blue filter cartridge is not activated in programming mode, you will not be prompted to change the filter. Precondition: FILTER / READY is displayed. c T Press the Maintenance button.
5 Maintenance T Open the powder chute for ground coffee and drop in a JURA cleaning tablet. CAUTION If the descaling operation is interrupted, there may be damage to the machine. T Allow the descaling programme to run to the end. CAUTION If the descaling agent comes into contact with sensitive surfaces (e.g. marble), damage cannot be ruled out. T Clean up any splashes immediately. T Close the powder chute for ground coffee. PRESS RINSE c T Press the Maintenance button.
de 5 T Place a receptacle under the hot-water spout. c T Press the Maintenance button. DE-SCALING, water flows out of the hot-water spout repeatedly. EMPTY TRAY T Empty the drip tray and coffee grounds container and reinsert them. FILL WATER TANK T Empty the receptacle and place it under the dual and hot-water spout. T Remove the water tank, rinse thoroughly, fill with fresh, cold water and reinsert. PRESS RINSE c T Press the Maintenance button.
6 Display messages 6 Display messages Message Cause/Result Action FILL WATER TANK The water tank is empty or not correctly inserted. You cannot prepare any products. T Fill the water tank (see Chapter 1 ‘Preparing and using for the first time – Filling the water tank’). T Insert the water tank. EMPTY GROUNDS The coffee grounds container is full. No speciality coffees can be prepared, but hot water preparation is possible.
de 7 7 Troubleshooting Troubleshooting Problem Cause/Result Action Insufficient foam is produced when the milk is frothed or milk sprays from the dual spout. The dual spout is dirty. T Clean the dual spout (see Chapter 5 ‘Maintenance – Cleaning the milk system’). T Dismantle and rinse the dual spout (see Chapter 5 ‘Maintenance – Dismantling and rinsing the dual spout’). Coffee only comes out in drips when it is being prepared.
8 8 Transport and environmentally friendly disposal Transport and environmentally 9 friendly disposal Transport / Emptying the system Technical data Voltage 220–240 V ~, 50 Hz Power 1450 W Keep the packaging for your ENA. It should be used to protect the machine during transport. Conformity mark AS Energy consumption Approx. 10.6 Wh In order to protect the ENA from frost during transport, the system must be emptied. ECONOMY - Precondition: READY is displayed.
de 10 10 A B C Index Index Addresses 59 Aroma preservation cover Bean container with aroma preservation cover 34 Automatic switch-off 46 Bean container Bean container with aroma preservation cover 34 Cleaning 53 Filling 39 Bus bar Technical data 56 Button Cappuccino button 35 Coffee button 35 Espresso button 35 Hot Water button 35 Latte Macchiato button 35 Maintenance button 35 On/Off button 35 Cappuccino 42 Cappuccino frother cleaning Cleaning the milk system 48 Cappuccino frother rinsing Rinsing the
10 L Index Language 47 Latte macchiato 42 R M Machine Cleaning 51 Descaling 52 Rinsing 48 Setting up 38 Switching off 44 Switching on 44 Mains cable 34 Maintenance Daily maintenance 44 Maintenance 48 Messages, display 54 Milk system Cleaning 48 Rinsing 48 P Permanently setting the water for the cup size 42 Permanent settings in programming mode 44 Powder chute Powder chute for ground coffee 35 Preparation 41, 42 Cappuccino 42 Coffee 42 Espresso 42 Ground coffee 43 Hot water 43 Latte macchiato 42 Pro
de 11 JURA contact details / Legal information 11 JURA contact details / Legal information en JURA Elektroapparate AG Kaffeeweltstrasse 10 CH-4626 Niederbuchsiten Tel. +41 (0)62 38 98 233 @@ You will find additional contact details for your country at www.jura.com.
J69783/ENA Micro 9/de-ru/201401 60