User`s guide

Troubleshooting Continued:
• Read the” One For All’s” troubleshooting section of the guide for
any additional troubleshooting tips.
• Try ALL of the codes listed for your device. Many set-up codes
may allow partial functionality; however, only one code will
operate your device correctly.
• Make sure that you are within 6-10 feet of your device, with the
remote facing the device, while programming. Make sure that
you are within 15 feet of your device when using your remote.
• If the red light on the remote control does not blink when you
press a key, replace the batteries with two (2) new AA alkaline
batteries. Be sure to install paying close attention to proper
battery polarity. *.
• * NOTE: When you replace your batteries, or remove them for
any reason, you must re-install batteries within 10 minutes, or re-
programming your remote will be required. This is why it is
important to write down the codes that work for your devices and
keep both these manuals in a safe place.
Care of Unit:
The Universal Remote can be wiped clean with any household multi-
purpose cleaner and disinfectant.
Do not submerge the unit, as it will damage the contents and the
electrical components.
Do not use abrasive cleaners, as they will scratch the surface of the
unit.
For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
1-800-TEC-TOYS or 1-800-832-8697
[e-mail]
Jumbo Universal Remote Control #1526
USER’S GUIDE
50 Broadway
Hawthorne, NY 10532
Tel. [phone] / Fax [phone]
Toll Free 800.832.8697
www.enablingdevices.com