Product Card

Users’ Manual Digital Node (Wireless-RF)
Page | 2
2 SETTING UP WIRELESS DIGITAL NODE
This section provides information on setting up a Digital Node to work with the offline ER Beam gateway.
2.1 Installation
The Nodes can be directly affixed to a flat surface using M6 screws. However, for more sophisticated
mounting scenarios, we recommend using the node bracket. The node bracket can be used to easily mount
the node on flat surfaces, on pipes using U-bolts or cable-ties, or in other complicated settings.
If you are using the bracket, first fix the node device to the bracket using M6 screws and nuts as shown
below.
Use four screws and nuts to attach the node to the bracket (Refer to figure 1).
Connect the SMA antenna to the bulkhead. Once the mounting is complete, the node should look as in
figure 2.
Figure 1: Attachment for nodes
Figure 2: Node (after installation)