Product Card

Users’ Manual Digital Node (Wireless-RF)
Page | 3
2.2 Node Setup
1 Connect the node antenna to the antenna bulkhead.
2 Connect the sensor wires to the node while ensuring that the wires are plugged in correctly.
PWR: +12 V Supply
GND: Ground
SIG1: Output Signal
SIG2: If reqd
SHLD: Shield wire of sensor
3 Switch off the Node and insert the battery while ensuring the correct polarity.
2.3 Configuring via the ER Offline App
1 Obtain an Android phone and connect it to the ER_Beam Wi-Fi network. (See the Gateway section to
learn about switching on the ER_Beam Wi-Fi network)
2 Connect the Android smartphone to the Node via an OTG adapter.
NOTE: Please make sure the Node is switch off before connecting to your Android phone.